Pianos regularly make movers annual list of products that are most regularly harmed. Grand pianos are especially bothersome. Practicing the following treatments for disassembling, cushioning and loading grand pianos will avoid damage, lower claims expenditure, and improve consumer complete satisfaction.
1) A minimum of three individuals are needed to manage a baby grand piano. If the infant grand piano requires to go up or down stairs or if a full or show grand piano requires to be transferred, a minimum of 4 people are needed.
2) Constantly complete a extensive and accurate inventory. It may be essential or more suitable to utilize a visual inventory to properly explain and reveal pre-existing damage.
3) As various parts are taken apart, please location all hardware in a properly labeled parts bag and then place the parts bag in a "Components Box".
4) Get rid of the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a tidy furnishings pad.
5) Disconnect the cover by removing the hinge pins. Have a single person wiggle the cover, holding it opposite the hinge, while a 2nd individual works the pin loose. Please be mindful not to harm the wood with the pliers or with the pin itself. Cover the jaws of the pliers with a little fabric to help prevent damage to the wood if necessary. Wrap the cover in a clean furnishings pad.
6) Eliminate the prop that holds the lid open and cover it in a tidy furniture pad. The prop has a hinge pin and remains in two pieces.
7) Eliminate the pedal assembly and cover it in a clean furniture pad. When removing the screws, please be careful not to drop the braces. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the appropriate number on each rod.
8) Pad the piano by placing a tidy rolled furnishings pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to prevent it from flopping open while you handle the piano. Note: Please ensure that the surface area of the piano is dust-free prior to padding it.
9) Position a piano board and connect the straps so that it is prepared to get the piano. The raised brace on the piano board should be at the keyboard end of the piano.
10) Remove the left front leg by placing one person below the piano at the left end of the keyboard. Be sure to have two people raising the corner of the piano while the third individual gets rid of the leg. Keep in mind: Please be sure to note which legs were gotten rid of from which positions since some pianos have legs that are not interchangeable.
11) Location the piano on the piano board by lowering the "leg-less" end onto the board. Please make sure to raise the whole piano slightly while completing this maneuver to avoid excessive pressure on the remaining, attached legs as the piano ideas. Raise the piano to an upright position on the board. Note: Please ensure that the soundboard is safe before lifting. Make sure that the piano is focused comfortably versus the brace at the end of the piano board. Keep in mind: Never ever leave the piano ignored. Constantly have at least a single person holding the piano consistent at all times.
12) Remove the 2 staying legs and wrap them in clean furniture pads. These legs are held in location by a "crucial and slot" plan. To eliminate the leg, slide it inward toward the center of the piano till it comes out of the slot.
13) Protect the piano to the piano board by bringing the ends of the straps together and fastening them. Place folded burlap pads over the furnishings pads however under the straps to provide extra security to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, connect the loose ends of the two straps together.
14) To move the piano over a flat, level surface area, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for security against house damage, place the keyboard end of the piano towards the bottom of the stairs. Connect a hump strap to the leading end of the piano board to avoid the piano from slipping.
16) To pack the piano, leave it on the piano board and location it in a tier as the first base product with the keyboard facing the wall of the preceding tier. The very best place to pack this page the cushioned lid is in between the piano and the preceding tier or in between the piano and the wall.
Grand pianos represent a considerable obstacle, they can be moved without damage by utilizing typical sense and practicing the procedures listed above.